Hi,
Can someone give me some advice on how to remove the crystal on my Wenger Aquagraph Tide watch, model 70832. This watch has a rotating bezel (rotates one direction only) with a mineral crystal. THese are my questions:
How does the bezel pop off (with a case knife?) Will some part goes flying out never to be found again?
Is the crystal glued in or is it a press fit between the bezel and case with a gasket in between?
Any other advice is welcome. By the way, I have a small arbor press to seat the new crystal in place. I may use a sapphire crystal to replace the original mineral.
Mike
Can someone give me some advice on how to remove the crystal on my Wenger Aquagraph Tide watch, model 70832. This watch has a rotating bezel (rotates one direction only) with a mineral crystal. THese are my questions:
How does the bezel pop off (with a case knife?) Will some part goes flying out never to be found again?
Is the crystal glued in or is it a press fit between the bezel and case with a gasket in between?
Any other advice is welcome. By the way, I have a small arbor press to seat the new crystal in place. I may use a sapphire crystal to replace the original mineral.
Mike