WATCH TALK FORUMS banner

1 - 2 of 2 Posts

·
Registered
Joined
·
29 Posts
Discussion Starter · #1 ·
Hi,

Can someone give me some advice on how to remove the crystal on my Wenger Aquagraph Tide watch, model 70832. This watch has a rotating bezel (rotates one direction only) with a mineral crystal. THese are my questions:

How does the bezel pop off (with a case knife?) Will some part goes flying out never to be found again?

Is the crystal glued in or is it a press fit between the bezel and case with a gasket in between?

Any other advice is welcome. By the way, I have a small arbor press to seat the new crystal in place. I may use a sapphire crystal to replace the original mineral.

Mike
 

·
Banned
Joined
·
2,466 Posts
Hi,

Can someone give me some advice on how to remove the crystal on my Wenger Aquagraph Tide watch, model 70832. This watch has a rotating bezel (rotates one direction only) with a mineral crystal. THese are my questions:

How does the bezel pop off (with a case knife?) Will some part goes flying out never to be found again?

Is the crystal glued in or is it a press fit between the bezel and case with a gasket in between?

Any other advice is welcome. By the way, I have a small arbor press to seat the new crystal in place. I may use a sapphire crystal to replace the original mineral.

Mike
First off welcome. I would'nt touch it just go to a professional watch maker you don't want to add more damage to the watch.:001_smile:
 
1 - 2 of 2 Posts
Top