WATCH TALK FORUMS banner
1 - 12 of 12 Posts

· Registered
Joined
·
469 Posts
Discussion Starter · #1 ·
Been a long time since I posted about a new Bulova. Went off on a little vintage Seiko quartz tangent and picked up a couple Orient divers BUT...

This popped up on a BIN on eBay at a killer price and I SNAPPED into action. Always have had a soft spot for vintage red LEDs. They're just so geeky (like me). :biggrin:

Without further ado, my N7 Bulova Computron. Original gold tone bracelet, all LED segments working, all functions working. I just can't press the button and get the phone to take a pic before it goes off again.

The back does have a personal engraving but I'm going to take a few detailed pics and see if Rob's case wizard can help me out with that.

Now I have to find the setting instructions!

Just too cool...

 

· Registered
Joined
·
210 Posts
KHatfull,
There were two different modules used in the trapezoids, one had a set button and a command button and the other just had one button, like yours. If you hold the button in for a little bit it will go into the setting mode. I don't remember what display flashes first, but once it starts flashing then you can change it by pressing the button as many times as needed. Pressing and holding will move it to the next setting mode. Keep repeating until all the modes are set correctly.
Samantha
 
1 - 12 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top