WATCH TALK FORUMS banner
1 - 13 of 13 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 · (Edited)
Just received an Invicta Sea Spider Skeleton and not sure how to size the band. Looked at a few youtube videos but none are the same style band. Thanks
 

·
Registered
Joined
·
169 Posts
Wish I could help more. I am not familiar with the brand. 48 hours and no reply is unacceptable IMHO. Hopefully others can chime in.
 

·
Registered
Joined
·
7 Posts
Discussion Starter · #10 · (Edited)
Success!

Success!
I decided to take a shot and I'm happy to say I was successful.
The pins between links are actually threaded posts and both ends are made for a slot screwdriver.
Its awkward but I put an eyeglass screwdriver on each end of the post and held one while turning the other.
One end unscrews a tiny bolt and then the pin can be pushed through, releasing that band link.
To reassemble I found wetting the pin made it slide into the rubber link much more smoothly. Like licking an inflation needle to pump up a ball
I hope this may help someone else and thanks for letting me share my small victory.
I include a pic to show post style pin and bolt.
Sorry for pic quality but you can see how it works.
100_1251.jpg
 

·
Premium Member
Joined
·
1,512 Posts
For future reference there is an Invicta forum here at Watch Talk Forum. BTW nice sea spider, and I'm glad you were able to figure it out.

Sent from my DROID X2 using Tapatalk
 
1 - 13 of 13 Posts
Top