WATCH TALK FORUMS banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
My wife ordered a stainless bracelet for my ball engineer master ii diver to replace the rubber strap in came with (the stainless was on option when she bought me the watch she just didn't know which I'd prefer). I had the bracelet fitted and installed at a local jeweler. Since the links remove with tiny screws I was hoping somebody could tell me what is the proper size screwdriver I need. I do not want to use the cheap screwdriver set that comes from the hardware store but I don't want to spend a fortune on a whole screwdriver kit that I don't need. Also I can see where the jeweler had a hard time with a couple of the screws. Does anybody know where I can get replacements?



Thanks for any help you can give me
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top