WATCH TALK FORUMS banner
1 - 2 of 2 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
Hi
I broke one of the hands on my Patria 1915 watch. I"m a totally a newbie but learning. The watch was very reasonably priced.
The Measurements of the shafts are 1.4 Hour 0.8 Minute
Length Minute 10.9 Hour 9.3

I ordered a min and hr. hands 86.8140.62 from Esslinger. This is the closest I could find to match the hands. I mapped out where 13mm will be on the watch face seemed ok. I don"t mind reducing the length if necessary. I think the hour hand will be fine.

Does anyone see a problem with doing this? I have a very modest budget. Seemed like a solution.
Thank you so much-Joseph
 

Attachments

1 - 2 of 2 Posts
Top